Locks and Dam 12 on the Mississippi river at Bellevue, IA.

The River With The Most Locks In America

A long barge tow on the Upper Mississippi River is sometimes too big to fit through a lock in one trip, so crews split it apart, move each half through separately, and reconnect it on the other side. That routine plays out across 29 lock-and-dam sites between Minneapolis, Minnesota, and the St. Louis area, more than on any other river in America. Together, they carry boats through about 420 feet of elevation change, and at Lock 19, a single chamber raises or lowers vessels more than 38 feet.

The Mississippi has far more navigation locks and dams operated by the US Army Corps of Engineers along its commercial channel than any other major American river. The Ohio River has 19 lock-and-dam systems. The McClellan-Kerr Arkansas River Navigation System has 18 and the Tennessee River has nine main navigation locks. The US Geological Survey describes the Mississippi's system as a "stairway of water."

The figure of 29 is a historical count of lock-and-dam sites. It includes Upper St. Anthony Falls Lock in Minneapolis, closed to navigation since 2015, so 28 sites still move boats up and down the river today.

Why The Upper Mississippi Needs Locks

Lock and Dam No 1 on the Mississippi River in Minneapolis
Lock and Dam No 1 on the Mississippi River in Minneapolis.

The Mississippi River drops about 420 feet over about 670 miles between the Twin Cities and the St. Louis area. Before engineers developed modern navigation systems, shallow waters, sandbars, rocks, and rapids made parts of the river difficult to navigate. During certain seasons, this left some stretches of the river too shallow for vessels carrying heavy cargo to navigate.

The US Army Corps of Engineers manages these water levels using dams to create long sections of navigable water. Locks help boats move between these areas without going over the dams.

Farther down the river, large tributaries add a lot of water. As a result, the Lower Mississippi is usually deep enough to navigate without a large number of locks.

How A Lock Works

Lock and Dam No 1, Mississippi River, Minneapolis
Close up of Lock and Dam No 1, Mississippi River, Minneapolis.

A lock consists of a chamber with gates on either end. When a boat arrives at a lock, the water level is changed to match the water level of the pool it is arriving from. Once inside the chamber, both gates shut. Water is added or removed to raise or lower the water level to match the water level on the other side. Once the far gates have opened, the boat can continue.

Many lock chambers on the Upper Mississippi are 600 feet long and 110 feet wide, but large commercial tows can include 15 barges arranged three wide and five long, plus a towboat. A tow of that size cannot fit inside a 600-foot chamber, so crews must separate the barges and move them through the lock in sections. The process, known as double lockage, increases the time needed to pass through the lock.

Navigation dams are not for flood control. Dredging clears away silt between them.

How The Locks Were Built

ock and dam sites on the Mississippi River allows for barges to navigate the River.
Lock and dam sites on the Mississippi River allows for barges to navigate the River.

Improvements to navigation on the Mississippi started in the 19th century, when Congress authorized a 4.5-foot-deep navigation channel in 1878. Almost 30 years later, in 1907, Congress authorized a six-foot-deep navigation channel. This was not deep enough for larger vessels with heavy cargo.

Congress authorized construction of the lock-and-dam system in 1930 to provide a nine-foot navigation channel under the Rivers and Harbors Act. During the 1930s, the Corps created locks and dams, dredged shallows and improved navigation. The main project was completed by 1940, but some locks and dams have not been updated since.

The first facility to be created as part of the nine-foot navigation project was Locks and Dam 15 in Rock Island, Illinois. It opened in March 1934 and was used as a model for others. The dam is unusual as all the movable gates are roller gates, according to the Corps fact sheet.

Three Locks With Different Roles

Mississippi River Lock and Dam 2.
Mississippi River Lock and Dam 2.

Lock 19, A Large Lift

Lock 19 has the second-highest lift on the Mississippi River. The current chamber opened in May 1957. The chamber is 1,200 feet long and 110 feet wide. The lift is about 38.2 feet, according to National Park Service historical information, and the chamber can fit a full-length barge tow.

It replaced an old chamber associated with the hydroelectric dam. The dam was completed in 1913. Vessels can go around the old Des Moines Rapids without breaking up a typical large tow.

Lock And Dam 2, High Commercial Traffic

Lock and Dam 2 has high levels of commercial traffic. Crews completed 1,268 commercial lockages in 2025, helping about 3,200 barges carry over 5.7 million tons of cargo. These figures were reported by the Army Corps in January 2026.

A total of 1,543 pleasure craft passed through the lock in 1,019 lockages. The number of vessels is higher than the number of lockages because many small boats can go through together.

Upper St. Anthony Falls, Now Closed

The Upper St. Anthony Falls Lock in Minneapolis, Minnesota, was closed to navigation on June 9, 2015. The last vessel to pass through was a pleasure craft. A commercial tow had passed through earlier that day. The lock closed because of federal legislation, according to the US Army Corps of Engineers.

The lock still counts toward the historical total of 29 lock-and-dam sites.

Why The Locks Matter

A towboat, known as a pusher, pushes barges full of cargo up the Mississippi River near downtown Baton Rouge, Louisiana, USA.
A towboat, known as a pusher, pushes barges full of cargo up the Mississippi River.

The Upper Mississippi River is used to transport grain, fuel, building materials and other products between inland ports and larger networks. Long barge tows can experience delays at the locks, especially when they need to be separated into sections.

The locks affect wildlife as well. Dams change water levels, silt, and connections between aquatic habitats. A study by the US Geological Survey in 2024 looked at how fish pass around several locks on the Upper Mississippi Riverr, including Lock 19, where fish traveling upstream must pass through the lock chamber.

Lock and Dam 25 near Winfield, Missouri, is being modernized with a new 1,200-foot chamber alongside the existing 600-foot lock. The larger chamber will help reduce delays for commercial tows, while the original lock will continue operating as an auxiliary chamber. The project is part of the Navigation and Ecosystem Sustainability Program.

A Century Of Locks On The Upper Mississippi

Spillway gates at Lock and Dam No. 11 on the Mississippi River near Dubuque, Iowa
Spillway gates at Lock and Dam No. 11 on the Mississippi River near Dubuque, Iowa.

The Upper Mississippi's 29 historic lock-and-dam sites have made commercial navigation possible through stretches once obstructed by shallow water and rapids. Nearly a century after construction began, the original 600-foot chambers still require crews to separate larger barge tows before passing through. The planned 1,200-foot chamber at Lock and Dam 25 will address that delay, but much of the original system continues to handle modern shipping. With 28 sites still open to navigation, the Upper Mississippi depends on an extensive network of locks to move freight between the Twin Cities and the St. Louis area.

Share

More in Bodies of Water